ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Camshaft Seal > < Timing Belt

Fiesta 1996 (08.1995-02.2002)

Engine - 1.8L Endura-DI (Lynx) Diesel - Camshaft Fiesta 1996 (08/1995-02/2002)
In-vehicle Repair

Materials
Name
Specification
Gasket Eliminator Sealant
WSK-M2G348-A5 

Removal

  1. Remove the camshaft seal.
    For additional information, refer to: Camshaft Seal (303-01E Engine - 1.8L Endura-DI (Lynx) Diesel, In-vehicle Repair).
  1. Check the valve clearances.
    For additional information, refer to: Valve Clearance (303-01E, General Procedures).

  1. CAUTION:
    CAUTION:Loosen the nuts of camshaft bearing caps number one, three, and five by one turn each until the camshaft is released.
    NOTE:
    NOTE:Keep the nuts and camshaft bearing caps in order.
    Remove the camshaft.

  1. NOTE:
    NOTE:Keep the valve tappets and adjustment shims in order.
    Remove the valve tappets and adjustment shims.

Installation
  1. NOTE:
    NOTE:Coat the valve tappets and adjustment shims with clean engine oil.
    Install the valve tappets and adjustment shims.

  1. NOTE:
    NOTE:The larger semi-circle points upwards.
    Install the camshaft.

  1. NOTE:
    NOTE:Coat the camshaft bearing caps with clean engine oil.
    Install the camshaft bearing caps.
    • Coat bearing cap number one with sealant on the marked surfaces.
  1. Check the valve clearances.
    For additional information, refer to: Valve Clearance (303-01E, General Procedures).
  1. Install the camshaft seal.
    For additional information, refer to: Camshaft Seal (303-01E Engine - 1.8L Endura-DI (Lynx) Diesel, In-vehicle Repair).

Camshaft Seal > < Timing Belt