Removal and Installation Removal | -
Remove the central junction box cover. | | -
Remove the two retaining screws. | | -
Push the central junction box two retaining clips to the center and detach the generic electronic box (GEM) and the central junction box. | | -
Turn the GEM 90 degrees up (fuses now on top). Remove the wiring protection plate. | | -
Detach the central junction box from the GEM. | | -
Remove the relays from the GEM. | | -
Remove the GEM (three electrical connectors). | Installation | -
To install, reverse the removal procedure. | | -
Use FDS 2000 to configure the new GEM. | | |