Five Hundred 2WD V6-3.0L VIN 1 (2006)
Rear Door Interior Handle: Service and Repair
Rear
INTERIOR DOOR HANDLE
Removal
NOTE: The front door is shown, the rear door is similar.
1. Remove the door trim panel.
2. Remove the bolt and position the interior door handle aside.
3. Disconnect the interior door handle actuating cable and remove the interior door handle.
Installation
1. Install the interior door handle and connect the interior door handle actuating cable.
2. Position the interior door handle and loosely install the bolt.
3. Install the door trim panel.
4. Center the inside door handle alignment pins to the front door trim panel and tighten the interior door handle bolt to 7 Nm (62 lb-in).
