Five Hundred 2WD V6-3.0L VIN 1 (2006)
3. NOTE: Bleed the longest line first. Make sure the bleeder tank contains enough specified brake fluid to complete the bleeding operation.
Place a box end wrench on the RH rear bleeder screw. Attach a rubber drain tube to the RH rear bleeder screw, and submerge the free end of the
tube in a container partially filled with clean brake fluid.
4. Open the valve on the bleeder tank.
5. Loosen the RH rear bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RH rear bleeder screw and remove the
rubber hose.
^
Press and release the parking brake 5 times.
^
Repeat until clear, bubble-free fluid comes out.
6. Tighten the RH rear bleeder screw and install the bleeder cap.
^
To install, tighten to 10 Nm (89 inch lbs.).
7. Repeat Steps 5 and 6 for the LH rear bleeder screw.
8. Continue bleeding the front of the system, going in order from the RH front disc brake caliper bleeder screw, ending with the LH front brake
caliper bleeder screw.
9. Close the bleeder tank valve. Remove the tank hose from the adapter, and remove the adapter.
Anti-Lock Brake System (ABS) Hydraulic Control Unit Bleeding
NOTE: When any part of the hydraulic system has been disconnected for repair or installation of new components, air can get into the system and
cause spongy brake pedal action. This requires bleeding of the hydraulic system, including the hydraulic control unit (HCU) after it has been correctly
connected.
NOTE: If the hydraulic control unit (HCU) or any component upstream of the HCU are installed new, carry out the Brake System Pressure Bleeding
procedure first without the diagnostic tool, followed by the Brake System Pressure Bleeding procedure using the diagnostic tool.
NOTE: This procedure is only required when a new hydraulic control unit is installed.
1. Connect the diagnostic tool and follow the ABS system bleed instructions.
2. Follow the pressure bleeding or manual bleeding procedure steps to bleed the system.