Five Hundred 2WD V6-3.0L VIN 1 (2006)
Using the special tool, install the crankshaft pulley.
4. Install the bolt and washer. Using the special tool to hold the crankshaft pulley, tighten the bolt in 4 stages:
^
Stage 1: Tighten to 120 Nm (89 ft. lbs.).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs.).
^
Stage 4: Tighten an additional 90 degrees.
5. Position the RH fender splash shield and install the pin-type retainers.
6. Install the accessory drive belt.
