Five Hundred 2WD V6-3.0L VIN 1 (2006)
Compass: Service and Repair
Compass Calibration
COMPASS CALIBRATION
1. NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential
electrical accessories (rear window defrost, heater A/C, map lamps, wipers, etc.) and make sure all doors are closed.
Start the vehicle.
2. NOTE: Do not select trip, DTE, or AFE. The top line of the message center must be blank.
Press the INFO button repeatedly until the compass and odometer are displayed in the message center.
3. NOTE: If the message center displays the message SLOW CIRCLES TO CALIBRATE, then continue with step 3. If the message center displays
a heading, continue with step 4.
Drive the vehicle in circles up to 3 times until the message CALIBRATION COMPLETED appears and 1 of the 8 valid headings (N, NE, E, SE,
S, SW, W, NW) is displayed.
4. Drive the vehicle in at least 1 circle to verify that the calibration process has taken place, confirming that the heading changes accordingly. If this
happens, the compass has been calibrated successfully. Otherwise, if the display shows only 1 heading as the vehicle is driven, repeat the
procedure from step 2.
