Five Hundred 2WD V6-3.0L VIN 1 (2006)
7. If fluid needs to be added, add clean CVT automatic transmission fluid in 0.25 L (1/2 pint) increments through the fluid fill plug located on the
top of the transaxle near the fluid level indicator. Do not overfill the transaxle and make sure the fluid temperature is in the correct range of 43°C -
47°C (109°F - 117°F), or internal damage to the transaxle will occur.
^
To install, tighten to 35 Nm (26 ft. lbs.).
^
The wrench light on the dash will illuminate if the fluid level is low during the fluid refill process and the vehicle may experience harsh
engagements.
Transmission Fluid Level Setting
Transmission Fluid Level Setting (CVT)
CAUTION: MERCON, MERCON V, MERCON SP, Motorcraft Premium Automatic Transmission Fluid and Motorcraft Continuously Variable
Chain type Transmission Fluid are not interchangeable transmission fluids. The use of any fluid other than what is recommended will cause
transmission damage.
CAUTION: CVT automatic transmission fluid is a unique fluid and has different expansion characteristics compared to other transmission fluids.
Correct fluid level setting must be done with the CVT transmission fluid in the 43° C-47° C (109° F-117° F) temperature range. Setting the fluid level
at any other temperature could cause an overfill condition and cause the fluid to leak from the vent and or cause internal transaxle damage.
NOTE: This procedure is for setting correct fluid level and can also be used to check correct fluid level.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Place the vehicle on a level surface.
3. Using the special tool, verify that the transmission fluid temperature is in the fluid level setting range 43°C - 47°C (109°F - 117°F).
4. Set the parking brake, place the range selector lever in PARK and run the engine at idle for 5 minutes.
