Five Hundred 2WD V6-3.0L VIN 1 (2006)
-
To install, tighten to 12 Nm (9 lb-ft).
3. Make sure the large RCM electrical connector position assurance lever is in the full release position before attempting to connect the connector.
4. CAUTION: Placing the large RCM electrical wiring connector into the RCM at an angle can cause bad electrical connections and
damage components.
Position the large RCM electrical wiring connector into the RCM.
-
CAUTION: Do not push the connector to where the lever pivots and seats itself. Light pressure is needed to get the connector into
position on the RCM before using the lever to fully seat the connector.
With the large RCM electrical wiring connector uniformly aligned to the RCM, lightly push in until a subtle audible click is heard and a slight
resistance is felt.
