Five Hundred 2WD V6-3.0L VIN 1 (2006)
6. Pull out to release the retainers and remove the load floor panel.
-
Use a suitable tool (pin-type retainer tool, etc.) to disengage the load floor from the seat.
7. Remove the screw, release the tab and remove the LH floor latch cover.
8. Remove the screw, release the tab and remove the RH floor latch cover.
9. Release the cushion trim cover retainers from the cushion frame and remove the trim cover and foam pad.
-
On assembly, the LATCH and child safety seat tether anchor must be accessible through the trim cover.
10. Remove the 8 cushion frame-to-pivot tube assembly bolts.
-
To install, tighten to 50 Nm (37 lb-ft).
11. Remove the cushion frame joining bracket and the cushion frame.
12. Remove the bolt and the RH safety belt buckle.
-
To install, tighten to 37 Nm (27 lb-ft).
13. NOTE: Make sure the anti-rotation tab is in place before tightening fastener.
To install, reverse the removal procedure.
14. Check the active restraint system for correct operation.
