Five Hundred 2WD V6-3.0L VIN 1 (2006)
Seat Belt Height Adjuster: Service and Repair
Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts
SAFETY BELT SHOULDER HEIGHT ADJUSTER WITH STRIPPED WELD NUTS
D-Ring Installation Kit
Special Tool(s)
1. Remove the shoulder safety belt height adjuster.
2. Use the 1/2-in drill provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. NOTE: After each rotation, back off the tap slightly to remove the new cuttings and be sure to blow out any chips before proceeding.
Apply a suitable lubricant to the M14x1.5 tap provided in the D-Ring Installation Kit and tap new threads.
4. Use a threaded insert (part of #N807170-S190) provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below
the surface.
