Five Hundred 2WD V6-3.0L VIN 1 (2006)
7. Using a pry bar, push the lower arm downward until the ball joint is clear of the lower arm.
8. After separating the lower arm ball joint from the wheel knuckle, immediately install the special tool over the ball stud before releasing the lower
arm and knuckle into the rest position.
^
Leave the special tool in place during service, only remove prior to reassembly.
9. CAUTION: Do not allow the halfshaft to move outboard. Overextension of the tripod CV joint can result in separation of internal parts, causing
failure of the halfshaft.
Using the special tool, press the halfshaft from the wheel bearing and hub. Support the halfshaft in a level position.
10. Remove and discard the strut-to-wheel knuckle nut and flagbolt.
^
To install, tighten to 175 Nm (129 ft. lbs.).
11. Remove the wheel knuckle.
^
If necessary, remove the wheel hub and bearing.
12. To install, reverse the removal procedure.
