Five Hundred 2WD V6-3.0L VIN 1 (2006)
Wheel Bearing: Service and Repair
Rear
Wheel Bearing and Wheel Hub
Special Tool(s)
Removal and Installation
All vehicles
1. Remove the brake disc.
2. Remove and discard the wheel bearing and hub-to-knuckle bolts.
^
To install, tighten to 120 Nm (89 ft. lbs.).
3. If equipped, remove the wheel speed sensor bolt and position the sensor aside.
^
To install, tighten to 8 Nm (71 inch lbs.).
AWD vehicles
4. Remove and discard the rear axle shaft nut.
^
To install, tighten to 200 Nm (148 ft. lbs.).
5. Using the special tool, press the axle shaft out of the hub.
All vehicles
6. NOTE: Always install new suspension fasteners.
To install, reverse the removal procedure.
