ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 5787 > < Initial Inspection and Diagnostic Overview|Page 5785
Page 2
background image

CVT Transaxle Cooler

CAUTION:  The clamps on the end of the fluid cooler tubes are glued to the tubes and are not to be removed. The clamps are part of the fluid tubes,
removing the clamps from the ends will damage the fluid cooler tubes.

6-Speed Transaxle Cooler

CAUTION:  The clamps on the end of the fluid cooler tubes are glued to the tubes and are not to be removed. The clamps are part of the fluid tubes,
removing the clamps from the ends will damage the fluid cooler tubes.

Removal and Installation

CAUTION:  MERCON, MERCON V, MERCON SP, Motorcraft Premium Automatic Transmission Fluid and Motorcraft Continuously Variable
Chain Type Transmission Fluid are not interchangeable transmission fluids. The use of any fluid other than what is recommended for this transmission
will cause transmission damage.

NOTE:  Refer to the following when adding transmission fluid.

^

The constant variable transmission (CVT) transaxle uses:
-

Motorcraft Continuously Variable Chain Type Transmission Fluid (XT-7-QCFT)

^

The 6-speed transaxle uses:
-

Motorcraft Premium Automatic Transmission Fluid (XT-8-QAW)

Do not mix the fluid together, damage to internal components will result.

Initial Inspection and Diagnostic Overview|Page 5787 > < Initial Inspection and Diagnostic Overview|Page 5785