Five Hundred 2WD V6-3.0L VIN 1 (2006)
6. Lubricate the 4 new O-ring seals in clean CVT automatic transmission fluid and install them on the fluid cooler tube.
7. CAUTION: Make sure the fluid cooler tubes are pushed in straight or the tubes and/or O-ring seals will be damaged.
Connect the transmission fluid cooler tubes to the pressure filter cover.
^
Tighten to 15 Nm (11 ft. lbs.).
Fluid pan and filter
8. CAUTION: Make sure that the fluid filter pickup tube seal was removed from the bore when the filter was removed. Failure to remove the seal
prior to installing the new filter will result in transaxle failure.
CAUTION: Make sure that the transmission fluid filter is fully seated into the bore. If the filter is not correctly installed, internal transaxle
damage will occur.
Install a new fluid filter and seal assembly.
