Five Hundred 2WD V6-3.0L VIN 1 (2006)
6. Lubricate the 4 new transmission fluid cooler tube seals in clean CVT automatic transmission fluid and install them onto the fluid cooler tubes.
7. CAUTION: Make sure the fluid cooler tubes are pushed in straight or the tubes and/or O-ring seals will be damaged.
Connect the transmission fluid cooler tubes to the transaxle.
^
Tighten to 10 Nm (89 inch lbs.).
8. Install the fluid cooler tube bracket to the transaxle.
^
Tighten to 10 Nm (89 inch lbs.).
9. If more fluid is needed, remove the fluid fill plug.
10. If required, top off the transaxle with clean CVT automatic transmission fluid. Use the transmission fluid level setting procedure to fill the
transaxle.
