Five Hundred 2WD V6-3.0L VIN 1 (2006)
3. Using new bolts, install the secondary cover. Tighten the bolts in sequence in 2 stages:
^
Stage 1: Tighten to 4 Nm (35 inch lbs.).
^
Stage 2: Tighten an additional 90°.
4. Carefully position the insulator over the retaining pins and install the 3 retainers.
5. Lubricate the 4 new seals in clean CVT automatic transmission fluid and install transmission fluid cooler tube seals.
6. CAUTION: Make sure the fluid cooler tubes are pushed in straight or the tubes and/or O-ring seals will be damaged.
Connect the transmission fluid cooler tubes to the transaxle.
^
Tighten to 10 Nm (89 inch lbs.).
