Five Hundred 2WD V6-3.0L VIN 1 (2006)
Transmission Mount: Service and Repair
Transaxle Support Insulator
Material
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the 2 bolts for the rear transaxle mount.
3. Install a suitable transmission jack to support the transaxle.
4. Remove the upper transaxle mount bolts and remove the mount.
Installation
1. Clean the rear transaxle mount bolts using a wire brush and apply new Threadlocker to the threads.
2. Position the transaxle mount in place and install the upper bolts.
^
Tighten to 55 Nm (41 ft. lbs.).
