ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Recall - Door Latch Freezing (Non-Cold/Wet States)|Page 8952 > < Recall - Door Latch Freezing (Non-Cold/Wet States)|Page 8950
Page 7
background image

SERVICE KIT CONTENTS

FRONT DOOR REPAIR - ALL FIVE HUNDRED AND MONTEGO VEHICLES AND CERTAIN FREESTYLE VEHICLES

NOTE:

Freestyle vehicles built from June 21, 2005 through December 14, 2005 do not require rain hat installation. Proceed directly to Door Latch Greasing
- All Vehicles in this Attachment III.

DOOR TRIM PANEL REMOVAL

1.

Remove the exterior mirror trim cover from the inner door panel, then disconnect the mirror control switch electrical connector.

2.

Remove the front door handle bezel screw cover, the screw and then the bezel.

3.

Remove the two (2) front door handle trim cover screws.

4.

CAUTION: Avoid pulling directly on the upper rear corner (vinyl portion) of the door trim panel during removal to prevent damage to the door
trim panel.

Remove the five (5) front door trim panel screws, then gently pull the door panel straight off the door to disengage the retaining clips.

5.

Disconnect the power window/door lock switch electrical connector.

6.

If equipped with power memory seat, disconnect the power memory seat electrical connector, then remove the front door trim panel from the
vehicle.

7.

Remove the water shield from the door module oval opening.

RAIN HAT INSTALLATION

1.

Reach into the opening to locate and remove the existing door latch cable shield as follows:

a)

Lift the shield up off the cable.

Recall - Door Latch Freezing (Non-Cold/Wet States)|Page 8952 > < Recall - Door Latch Freezing (Non-Cold/Wet States)|Page 8950