Five Hundred AWD V6-3.0L VIN 1 (2005)
5.
Peel the backing oft a piece of supplied polyethylene tape and apply it as follows: See Figure 9.
a)
Position the tape so that it covers approximately 20 mm (3/4 in) of the rear of the channel.
b)
Position the tape so that it is affixed to the horizontal surface of the rubber trim at the bottom of the glass. keep the tape on the horizontal
surface only or it may be visible after the belt moulding is reinstalled.
c)
Press the tape firmly into place.
6.
Reinstall the moulding by first installing the front end of the moulding in the channel then pushing it down and through the polyethylene tape, then
attach the moulding to the clip at the rear of the door. The moulding should sit flush against the door.
7.
NOTE: The kit includes only one (1) extra tape strip.
Check to make sure the tape is not visible after the moulding is installed. It it is, remove the moulding and the tape, clean the area of all adhesive
residue, then repeat Steps 4 through 7 using the extra piece of tape in the kit. Do not reapply the same piece of tape.
8.
Reinstall the belt moulding screw.
9.
Perform Steps 2 through 8 on the other rear door.
