Five Hundred AWD V6-3.0L VIN 1 (2005)
19. NOTE: Freestyle shown, Five Hundred and Montego similar.
Attach the restraint system diagnostic tools to the vehicle harness side of the passenger air bag module electrical connectors.
Vehicles without side air bags
20. CAUTION: Do not deactivate the side air bag module circuit by removing the side air bag bridge resistor from the side air bag electrical
connector.
If the side air bag bridge resistor is removed, an open circuit fault will be generated by the restraints control module (RCM). If a restraint system
diagnostic tool is installed at the side air bag floor electrical connector, a low resistance fault will be generated by the RCM.
Vehicles with side air bags
21. From under the rear of the passenger seat, slide and disengage the passenger seat side air bag module electrical connector locking clip, and then
release the tab and disconnect the passenger seat side air bag module electrical connector.
22. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger seat side air bag module electrical connector.
