ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Body - Lower Body Paint Damage|Page 9463 > < Body - Lower Body Paint Damage|Page 9457
Page 1
background image

Paint: All Technical Service Bulletins
Body - Lower Body Paint Damage

TSB 05-26-8

12/31/05

PAINT DEGRADATION TO BODY SIDE

FORD:
2005-2006 Five Hundred

MERCURY:
2005-2006 Montego

ISSUE
Some 2005-2006 Five Hundred/Montego vehicles driven in certain conditions may exhibit abrasion on the paint finish at the dog leg area of the rear
quarter panel. The abrasion results from the lack of moldings and wheel cuffs to prevent small debris in the front tires from striking a limited portion of
the lower quarter of the vehicle. In severe cases, the abrasion may result in the removal of the paint finish down to the bare metal at the dog leg area
(Figure 1).

ACTION
Repair paint on affected areas using standard labor times and procedures, then install door body side moldings and mud spats.

NOTE

PER THE WARRANTY & POLICY MANUAL, PAINT DAMAGE CAUSED BY CONDITIONS SUCH AS CHIPS, SCRATCHES, DENTS,
DINGS, ROAD SALT, STONE CHIPS OR OTHER ACTS OF NATURE, ARE NOT COVERED UNDER THE NEW VEHICLE LIMITED
WARRANTY. HOWEVER, PAINT ABRASION AT THE DOG LEG AREA IS A UNIQUE CONDITION ON THE FIVE HUNDRED AND
MONTEGO. AS A RESULT, REPAIRS ARE ELIGIBLE FOR BASIC WARRANTY COVERAGE.

NOTE

PAINT STRIPPING LABOR OPERATIONS ARE NOT TO BE CLAIMED IN CONJUNCTION WITH THIS REPAIR.

NOTE

PRIOR TO INSTALLING DOOR MOLDINGS, PAINT TO MATCH EXTERIOR VEHICLE BODY COLOR (BASE COLOR COAT/CLEAR
COAT).

INSTALLATION PROCEDURE

FRONT MUD SPAT INSTALLATION

1.

Raise vehicle on hoist. Refer to Workshop Manual, Section 100-02.

2.

Remove front wheel. Refer to Workshop Manual, Section 204-04.

3.

Remove the two (2) push pins that attach the splash shield to the fender.

4.

Remove the scrivet (screw/rivet) that attaches the splash shield to the rocker molding.

Body - Lower Body Paint Damage|Page 9463 > < Body - Lower Body Paint Damage|Page 9457