Five Hundred AWD V6-3.0L VIN 1 (2005)
8.
Reinstall headliner.
Vehicle Not Equipped With Side Air Curtains
Left Side NON-AIRBAG
1.
Pull back, but do not remove, rear quarter trim panel following procedure in WSM, Section 501-05.
2.
Remove and discard first and second hanger clips from the drain tube.
3.
Pull rear grommet out and disconnect remaining four (4) clips.
4.
Move the two (2) existing foam blocks to new locations. (Figure 3)
5.
Reroute and attach front of drain tube based on vehicle equipment. (Figure 3)
a.
For vehicles equipped with rear A/C, using a standard tie strap(s) (may need to use two (2) depending on length of strap) attach drain tube to
the top of the auxiliary A/C duct. Pull the drain tube taught before fully securing. Using another tie strap(s), attach drain tube to the base of
the B-pillar A/C duct, near seat belt retractor. Be sure to pull the drain tube taught before fully securing.
b.
For vehicle not equipped with rear A/C, tape drain tube to wiring harness in two locations, between existing retainers.
6.
Route remaining drain tube to exit location and adjust drain tube grommet to fit drain tube exit hole.
7.
Cut excess drain tube leaving 2" (50 mm) below grommet.
Right side NON-AIRBAG
1.
Remove and discard first and second hanger clips from the drain tube.
