Five Hundred AWD V6-3.0L VIN 1 (2005)
Manual passenger seat with a service kit OCS
19. Detach the OCS service kit ECU and seat wiring harness electrical connector.
1
Detach the OCS service kit electrical connector from the seat track.
2
Remove the tie strap retaining the unused pressure sensor electrical connector of the seat wiring harness.
20. Lift the foam pad, trim cover and bladder and move aside to access the seat track nuts.
-
When installing, make sure the safety belt buckle is positioned through the seat cushion trim cover opening.
All seats
21. Remove the 4 nuts and the seat track.
-
To install, tighten to 33 Nm (24 lb-ft).
22. NOTE: The memory seat track position sensors are integral to the memory seat track motors. The memory seat track motor electrical connectors
will connect to a seat track without the memory option. Make sure the correct seat track is being installed.
To install, reverse the removal procedure.
23. Install the seat.
24. Repower the SRS. Do not prove out the SRS at this time.
Passenger seat
25. WARNING: Do not separate components.
CAUTION:
-
It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed or an OCS
service kit is installed. A diagnostic tool is used to trigger the active command to carry out rezeroing of the OCS system.
-
Make sure the seat is completely assembled before rezeroing.
-
The following precautions must be taken before rezeroing the OCS system.
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the OCS system is not at a temperature below 0°C (32°F) or above 45°C (113°F) when initiating the rezeroing process.
If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within
the limits, 0°C to 45°C (32°F to 113°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before rezeroing and nothing is placed on the seat during the rezeroing
process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the rezeroing process.
NOTE:
-
For best results in rezeroing, the OCS system should be at or near room temperature, 10°C to 29°C (50°F to 85°F).
