Five Hundred AWD V6-3.0L VIN 1 (2005)
Place a box end wrench on the RH rear bleeder screw. Attach a rubber drain tube to the RH rear bleeder screw, and submerge the free end of the
tube in a container partially filled with clean brake fluid.
4. Open the valve on the bleeder tank.
5. Loosen the RH rear bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RH rear bleeder screw and remove the
rubber hose.
^
Press and release the parking brake 5 times.
^
Repeat until clear, bubble-free fluid comes out.
6. Tighten the RH rear bleeder screw and install the bleeder cap.
^
To install, tighten to 10 Nm (89 inch lbs.).
7. Repeat Steps 5 and 6 for the LH rear bleeder screw.
8. Continue bleeding the front of the system, going in order from the RH front disc brake caliper bleeder screw, ending with the LH front brake
caliper bleeder screw.
9. Close the bleeder tank valve. Remove the tank hose from the adapter, and remove the adapter.
