Five Hundred AWD V6-3.0L VIN 1 (2005)
26. CAUTION: To avoid loss of coolant, or unintended damage to an auxiliary line that is not being removed, clearly differentiate which line
is to be removed before cutting.
Assemble and lay out the replacement line(s) in the same position as the existing line(s) and, using a suitable tool, cut the auxiliary evaporator
line(s) in the same position as the middle fitting on the replacement line(s).
-
To install, connect the middle auxiliary evaporator line fitting(s).
27. Remove the front auxiliary line bracket nut.
-
To install, tighten to 5 Nm (44 lb-in).
28. Remove the front auxiliary line bracket.
29. Remove the front portion of the auxiliary evaporator outlet line and/or auxiliary evaporator inlet line.
30. Remove the rear auxiliary line bracket nut.
-
To install, tighten to 5 Nm (44 lb-in).
31. Remove the rear auxiliary line bracket.
32. Remove the rear portion of the auxiliary evaporator outlet line and/or the auxiliary evaporator inlet line.
33. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
34. Evacuate, leak test and charge the refrigerant system.
