Five Hundred AWD V6-3.0L VIN 1 (2005)
23. From under the rear of the driver seat, slide and disengage the driver seat side air bag module electrical connector locking clip, and then release
the tab and disconnect the driver seat side air bag module electrical connector.
24. Attach the restraint system diagnostic tool to the vehicle harness side of the driver seat side air bag module electrical connector.
Vehicles without safety canopy modules
25. CAUTION: Do not deactivate the safety canopy module circuit by removing the safety canopy bridge resistor from the safety canopy
electrical connector.
If the safety canopy bridge resistor is removed, an open circuit fault will be generated by the restraints control module (RCM). If a restraint system
diagnostic tool is installed at the safety canopy electrical connector, a low resistance fault will be generated by the RCM.
Freestyle with safety canopy modules
26. Release and position aside the driver side D-pillar trim panel.