Five Hundred AWD V6-3.0L VIN 1 (2005)
the driver air bag module to the steering wheel. Failure to follow this instruction will result in incorrect installation of the driver air bag module
and may result in personal injury in the event of a driver air bag module deployment.
NOTE: Follow each step of the wire clip resetting procedure precisely to make sure of correct driver air bag module installation.
Push the driver air bag module wire clip fully back on the 6 tabs on the top of the module.
24. While making sure the wire clip stays fully seated on the 6 tabs on the top of the module, use a suitable tool to reset the end of the wire clip that is
on the top.
1
Carefully lift the 1 end of the wire clip over the post.
2
Pull the wire clip outward to reset.
25. While still making sure the wire clip stays fully seated on the 6 tabs on the top of the module, use a suitable tool to reset the other end of the wire
clip.
1
Carefully lift the other end of the wire clip over the post.
2
Pull the wire clip outward to reset.
26. When the wire clip is reset correctly, it should appear as shown.
-
Make sure the wire clip hook ends are evenly spaced from the center post.
