Five Hundred AWD V6-3.0L VIN 1 (2005)
Vehicle Lifting: Description and Operation
JACKING
WARNING: Never run the engine with one wheel off the ground, such as when changing a tire. The wheel still on the ground could cause the
vehicle to move. Failure to follow these instructions may result in personal injury.
CAUTION:
-
The jack provided with the vehicle is intended to be used in an emergency for changing a deflated tire. To avoid damage to the vehicle,
never use the jack to hoist the vehicle for any other purpose. Refer to the Owner Literature when using the jack supplied with the vehicle.
-
Under no circumstances should the vehicle ever be lifted by the front or rear control arms, halfshafts or front wheel constant velocity
(CV) joints. Severe damage to the vehicle could result.
-
Do not attempt to use jack pressure on either the front bumper or the rear bumper of any vehicle. Damage to bumper covers will occur.
Lift the vehicle using the jacking points. Refer to the following illustrations.
Jacking Points
Front Jacking Points
To lift the front or either side of the front end, position the floor jack under the pinch point notches.
Rear Jacking Points
To lift the rear or either side of the rear end, position the floor jack under the pinch point notches.
LIFTING
CAUTION: Do not allow the lift arms, pads or adapters to contact the front or rear control arms, halfshafts, front wheel constant velocity
(CV) joints, steering linkage, stabilizer bar, or compress the stabilizer bar link insulators. Damage to suspension, exhaust and steering linkage
components may occur if care is not exercised when positioning the lift adapters prior to lifting the vehicle.
NOTE: Adapters may be necessary to clear vehicle components to lift the vehicle safely. The adapters must be placed at the 4 designated contact points.
Position the adapters so they are centered on the adapter contact area.
Refer to the applicable procedure to lift the vehicle.
