Five Hundred AWD V6-3.0L VIN 1 (2005)
Seats with manual seat track
4. NOTE:
-
When installing a new occupant classification sensor, the main seat wire harness pressure sensor electrical connector is not used.
-
The ECU must be correctly positioned and securely riveted in place. Failure to do so can set a diagnostic trouble code (DTC) in the restraints
control module.
Attach and connect the occupant classification sensor components.
1
Position the electronic control unit onto the seat cushion frame bracket and install new rivets.
2
Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining tab is completely engaged.
-
Make sure the pressure sensor hose is routed correctly and is not kinked during installation.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
3
Connect the main seat wire harness occupant classification sensor electrical connector to the service kit occupant classification sensor
electrical connector, and then attach the connector pin-type retainer to the seat track bracket.
4
Tie strap the wire harness and electrical connector safely out of the way.
Seats with power