Five Hundred AWD V6-3.0L VIN 1 (2005)
5. NOTE:
-
When installing a new occupant classification sensor, the main seat wire harness pressure sensor electrical connector is not used.
-
The ECU must be correctly positioned and securely riveted in place. Failure to do so can set a diagnostic trouble code (DTC) in the restraints
control module.
Attach and connect the occupant classification sensor components.
1
Position the electronic control unit onto the seat cushion frame bracket and install new rivets.
2
Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining tab is completely engaged.
-
Make sure the pressure sensor hose is routed correctly and is not kinked during installation.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
3
Connect the main seat wire harness occupant classification sensor electrical connector to the service kit occupant classification sensor
electrical connector, and then attach the connector pin-type retainer to the seat track bracket.
4
Tie strap the wire harness and electrical connector safely out of the way.
All seats
6. CAUTION: Inspect the seat cushion pad and seat cushion trim cover for any foreign objects, before installing the seat cushion trim cover
to the seat cushion pad. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an
air bag deployment.
Align the seat cushion trim cover to the seat cushion foam pad and attach the hog rings.
7. Attach the hook and loop strip at the rear of the seat cushion trim cover.
8. Attach all the seat cushion trim cover J-clips.
Seats with heat
9. Connect the heated seat electrical connector.
