Five Hundred AWD V6-3.0L VIN 1 (2005)
Power Seat Switch: Service and Repair
SEAT CONTROL SWITCH
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the supplemental restraint system (SRS) must be
depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Position the seat to access all the seat track-to-floor pan bolts and the safety belt anchor.
2. Depower the SRS.
3. Remove the front seat.
Seats with manual recline
4. Pull out and remove the manual recline handle.
All seats
5. Remove the seat control switch knob and power recline knob (if equipped).
6. Remove the rear screw, pull out on the side and front and separate the side shield.
7. Release the seat control switch wire harness pin-type retainer and remove the seat control switch from the side shield. Disconnect and remove the
seat control switch.
8. To install, reverse the removal procedure.
9. Install the front seat.
10. Repower the SRS.
