Five Hundred AWD V6-3.0L VIN 1 (2005)
Front Steering Knuckle: Service and Repair
Front
Wheel Knuckle
Special Tool(s)
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in
major service expense. A new part with the same part number must be used if installation is necessary. Do not use a new part of lesser quality or
substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Remove and discard the front axle wheel hub nut.
^
To install, tighten to 200 Nm (148 ft. lbs.).
2. Remove the wheel and tire assembly.
3. Remove the tie-rod-to-wheel knuckle nut, then separate the tie-rod from the wheel knuckle.
^
To install, tighten to 115 Nm (85 ft. lbs.).
4. Remove the front brake disc.
