Five Hundred AWD V6-3.0L VIN 1 (2005)
5. Remove the bolt and the wheel speed sensor from the wheel knuckle. Position the wheel speed sensor aside.
^
To install, tighten to 14 Nm (10 ft. lbs.).
6. NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Using a crow's foot wrench, remove and discard the lower arm ball joint nut.
^
To install, tighten to 115 Nm (85 ft. lbs.).
7. Using a pry bar, push the lower arm downward until the ball joint is clear of the lower arm.
8. After separating the lower arm ball joint from the wheel knuckle, immediately install the special tool over the ball stud before releasing the lower
arm and knuckle into the rest position.
^
Leave the special tool in place during service, only remove prior to reassembly.
