Five Hundred AWD V6-3.0L VIN 1 (2005)
7. Disconnect the power steering pressure line fitting-to-pump adapter.
^
Discard the Teflon seal.
8. Remove the 3 nuts and the power steering pump.
^
Rotate the power steering pump pulley to access the nuts through the holes.
Installation
1. NOTE: Whenever a hose fitting with a Teflon is disconnected, a new Teflon seal must be installed.
Using the special tool, install a new Teflon seal on the power steering pressure line fitting and the power steering pressure line fitting-to-pump
adapter.
2. Install the power steering pump and the 3 nuts.
^
Rotate the power steering pump pulley to access the nuts through the holes.
^
Tighten to 25 Nm (18 ft. lbs.).
3. Install the power steering pressure line fitting-to-pump adapter.
^
Tighten to 65 Nm (48 ft. lbs.).
4. Connect the power steering pressure line fitting.
^
Tighten to 65 Nm (48 ft. lbs.).
5. Install the power steering fluid reservoir.
6. Install the engine accessory drive belt.
7. Position the degas bottle and install the 2 bolts.
^
Tighten to 7 Nm (62 inch lbs.).
^
Connect the fill sensor electrical connector.