Five Hundred AWD V6-3.0L VIN 1 (2005)
1. Install new O-ring seals on the feed tubes.
1
Align the inner tube and install new O-ring seals on the inside and outside clutch (manual valve) supply feed tube.
2
Install new O-ring seals on the primary pressure feed tube.
3
Install new O-ring seals on the secondary pressure feed tube.
4
Install new O-ring seals on the main (pump) pressure feed tube (smaller tube).
2. CAUTION: Lubricate all of the O-ring seals with clean CVT automatic transmission fluid. Be careful not to nick, cut or damage the O-ring seals
when installing the mechatronic assembly or internal damage to the transaxle will occur.
NOTE: Note the location of the 5 feed tubes.
Lubricate the O-ring seals with clean CVT automatic transmission fluid and install all of the feed tubes into the case.
1
Align the inner tube and install the clutch (manual valve) supply feed tube.
2
Install the primary pressure feed tube.
3
Install the secondary pressure feed tube.
4
Install the main (pump) pressure feed tube (smaller tube).
5
Install a new torque converter clutch pressure feed tube.
3. CAUTION: Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic unit.
Position the mechatronic unit onto the case.
