Five Hundred AWD V6-3.0L VIN 1 (2005)
11. Install the fluid pan and the bolts. Tighten in the sequence shown.
^
Tighten to 12 Nm (9 ft. lbs.).
12. Install the fluid pan drain plug.
^
Tighten to 25 Nm (18 ft. lbs.).
13. CAUTION: Do not touch the electrical connector pins. Electrostatic charge may occur and will cause damage to the mechatronic unit.
Connect the transaxle bulk head electrical connector.
14. Fill the transaxle with approximately 4.7 Liters (5 quarts) of clean CVT automatic transmission fluid. Use the transmission fluid level setting
procedure to fill the transaxle.
15. If a new transaxle or a mechatronic main control valve body assembly is installed, the TCM will need to be reflashed to the latest level calibration
available. If the TCM is not reflashed, the wrench light on the dash may illuminate and internal transaxle damage may occur.
