Five Hundred AWD V6-3.0L VIN 1 (2005)
7. Remove the center bearing bracket bolts, then remove the driveshaft.
^
To install, tighten to 25 Nm (18 ft. lbs.).
8. If installing a new driveshaft, remove the center bearing bolts and the center bearing bracket.
^
To install, tighten to 20 Nm (15 ft. lbs.).
9. WARNING: Always install new driveshaft flange bolts.
NOTE: Hand-tighten the driveshaft flange bolts to the PTO flange and the rear axle pinion flange before tightening the center bearing bracket
bolts.
To install, reverse the removal procedure.
