Five Hundred AWD V6-3.0L VIN 1 (2005)
3.
Remove the deflector (7H459) from the PTU input shaft. (Figure 2)
4.
Remove the input shaft seal (7H429).
5.
Use Loctite(R) 7070 or equivalent cleaner to clean PTU seal area of dirt/oil.
6.
Verify that no residual cleaner remains on the PTU seal area.
7.
Install a new seal with the seal installer (205-815) per the Workshop Manual, Section 308-07.
8.
Apply a bead of Loctite(R) 410 to seal/PTU interface, 360° around the seal. (Figure 3)
NOTE
DO NOT OVER APPLY.
9.
Allow Loctite(R) to cure for at least 1 minute.
