Five Hundred AWD V6-3.0L VIN 1 (2005)
13. Remove the 11 bolts from the door module.
-
To install, tighten to 8 Nm (71 lb-in).
14. Remove the 3 door latch screws.
-
To install, tighten to 12 Nm (9 lb-ft).
15. Disconnect the 6 wiring harness retainers and the 2 connector retainers from the inside of the door module, then feed the wiring harness through
the door module.
16. Remove the front door module. If installing a new door module, transfer parts as necessary.
17. To install, reverse the removal procedure.
-
If installing a new LH front window motor, it must be initialized. If installing the original LH front window motor, it must be de-initialized,
then initialized.
