ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6701 > < Initial Inspection and Diagnostic Overview|Page 6699
Page 16
background image

-

Is the resistance less than 5 ohms?

Yes

GO to AD12.

No

REPAIR circuit CBP33 (WH/BN) for an open. TEST the system for normal operation.

-------------------------------------------------
AD8 CHECK FOR VOLTAGE AT THE TRAILER TOW CONNECTOR (BATTERY CHARGE ALWAYS ON)

-

Ignition OFF.

-

Measure the voltage between the trailer tow connector battery charge voltage supply pin, circuit CAT14 (OG), component side and ground.

-

Is any voltage present?

Yes

GO to AD9.

No

The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility.

-------------------------------------------------
AD9 CHECK TRAILER TOW BATTERY CHARGE RELAY OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE

-

Disconnect: Trailer Battery Charge Relay.

-

Measure the voltage between the trailer tow connector battery charge voltage supply pin, circuit CAT14 (OG), component side and ground.

-

Is any voltage present?

Yes

REPAIR circuit CAT14 (OG) for a short to voltage. TEST the system for normal operation.

No

GO to AD10.

-------------------------------------------------
AD10 CHECK THE TRAILER TOW BATTERY CHARGE RELAY COIL VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE

Initial Inspection and Diagnostic Overview|Page 6701 > < Initial Inspection and Diagnostic Overview|Page 6699