ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6786 > < Initial Inspection and Diagnostic Overview|Page 6784
Page 10
background image

-

Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage.

-

Does the battery voltage rise to 15.5 volts or higher?

Yes

REFER to Charging System to diagnose an overcharging condition.

No

GO to B3.

-------------------------------------------------
B3 RECHECK FOR DTC B1317

-

Turn the engine off.

-

Ignition ON.

-

Enter the following diagnostic mode on the scan tool: SJB Self-Test.

-

Clear the continuous memory DTCs.

-

Carry out the SJB self-test.

-

Is DTC B1317 present?

Yes

INSTALL a new SJB. REFER to Smart Junction Box (SJB)  See: Power and Ground Distribution/Power Distribution Module/Service and Repair. TEST
the system for normal operation.

No

The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.

-------------------------------------------------

Pinpoint Test C: DTC B1318

Smart Junction Box (SJB)

Pinpoint Tests

Pinpoint Test C: DTC B1318

Refer to Wiring Diagram Set 13, Power Distribution/SJB for schematic and connector information.  See: Diagrams/Electrical Diagrams/Diagrams By
Number

Normal Operation

The Smart Junction Box (SJB) monitors the voltage from the battery to determine if it goes above or below specific thresholds and sets DTC B1318 in
continuous memory and on-demand if the SJB detects low battery voltage below 10 volts on circuit SBB01 (RD).

-

DTC B1318 (Battery Voltage Low) - a continuous memory or on-demand DTC that sets when the SJB detects battery voltage below 10 volts on
circuit SBB01 (RD).

This pinpoint test is intended to diagnose the following:

-

Wiring, terminals or connectors

-

High circuit resistance

-

SJB

PINPOINT TEST C: DTC B1318

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.

NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.

-------------------------------------------------
C1 RECHECK THE SJB DTCs

Initial Inspection and Diagnostic Overview|Page 6786 > < Initial Inspection and Diagnostic Overview|Page 6784