Flex AWD V6-3.5L (2009)
14. Disconnect the keyless entry keypad (if equipped) electrical connector and unclip the harness from the door.
15. Remove the 3 front door latch bolts.
-
To install, tighten to 8 Nm (71 lb-in).
16. Remove the complete latch, carrier, and handle reinforcement assembly from the door.
17. Detach the lock cylinder rod from the lock cylinder lever (if equipped).
18. Open the clip and disconnect the exterior front door handle actuating rod.
19. Unclip and remove the exterior front door handle reinforcement from the carrier.
20. To install, reverse the removal procedure.
