Flex AWD V6-3.5L (2009)
Front Door Panel: Service and Repair
Door Trim Panel - Front
Removal and Installation
1. Remove the front door trim panel reflector and remove the front door trim panel rear screw.
2. Remove the front inside door handle screw cover.
3. Remove the front inside door handle screw.
4. Remove the door trim panel center screw cover.
5. Remove the door trim panel center screw.
6. Remove the 4 front door trim panel screws.
7. Pull upward to remove the window control switch and disconnect the electrical connectors.
8. Remove the front door trim panel bumper screw.
9. NOTICE: Avoid pulling directly on the upper rear corner (vinyl portion) of the door trim panel during removal to prevent damage to the
door trim panel.
Remove the front door trim panel.
-
If equipped, disconnect the electrical connectors.
-
Position the inside door handle through the front door trim panel.
