Flex AWD V6-3.5L (2009)
10. Remove the power steering cooler bolts.
-
To install, tighten to 10 Nm (89 lb-in).
11. Release the pushpins retaining the power steering cooler lines located on the side of the radiator grille support. Lower and secure the cooler to
allow clearance for removal of the radiator grille support.
12. Release the cooling module retainers from the radiator grille support.
13. Remove the 6 radiator grille support bolts (3 each side). Remove the support.
-
To install, tighten to 20 Nm (177 lb-in).
14. NOTICE: Inspect and transfer all of the radiator grille support insulters. Replace as necessary.
NOTICE: When installing the cooling module retaining clips, push the cooling module retaining clips toward the radiator grille support
until the clips are properly secured and a snap is heard. Failure to properly secure the cooling module retaining clips may cause damage
to the radiator or the cooling module assembly.
To install, reverse the removal procedure.
-
Transfer all necessary components.
