Flex AWD V6-3.5L (2009)
Switch the ignition from the OFF to the RUN state.
2. Press the unlock button on the door lock control switch 3 times.
3. Switch the ignition from the RUN to the OFF state.
4. Press the unlock button on the door lock control switch 3 times.
5. Switch the ignition back to the RUN state. The horn chirps once to indicate that programming mode is entered.
6. NOTE: The unlock button must be pressed twice within 5 seconds.
Within 30 seconds of entering the programming mode, press the unlock button on the door lock control switch twice to enable/disable the
perimeter lighting feature. The horn chirps once if the perimeter lighting is disabled or a chirp followed by a honk if the perimeter lighting is
enabled.
7. Switch the ignition to the OFF state. The horn chirps once to signal that the programming is complete.
Stepped Unlock Programming
Stepped Unlock Programming
1. With the ignition switch in the OFF position, press the LOCK and UNLOCK buttons on the Remote Keyless Entry (RKE) transmitter
simultaneously for 4 seconds.
-
The turn signals will flash twice to indicate the mode change.
2. Repeat Step 1 to enable/disable the stepped unlocking feature.
