Flex AWD V6-3.5L (2009)
5. Invert the backrest trim cover up and remove the 3 second row hog rings.
6. From the rear of the backrest, separate the backrest trim cover J-clip attached to the backrest frame wire.
7. Squeeze the ends of the deployment chute clips together and open the deployment chute.
8. Invert the backrest trim cover up and pull the deployment chute through the backrest foam pad.
9. Remove the backrest trim cover.
10. If equipped, disconnect the backrest heated seat mat electrical connector and separate the connector pin-type retainer from the backrest frame.
11. Remove the backrest frame assembly from the backrest foam pad.
12. Separate the side air bag module wire harness retainers from the backrest frame.
