Flex AWD V6-3.5L (2009)
Removal
WARNING: Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the
body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may
result in serious personal injury in the event of an accidental deployment.
WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
WARNING: Front seat backrest trim covers installed on seats equipped with seat side air bags cannot be repaired. A new trim cover must be
installed. Cleaning is permissible. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and
increase the risk of serious personal injury or death in a crash.
NOTE: If a side air bag deployment took place, a new seat backrest foam pad, backrest trim cover, deployment chute and side air bag module and nuts
must be installed. A new seat backrest frame should be installed if necessary.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the driver seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
2. Remove the 2 head restraint guides sleeves. For additional information, refer to Head Restraint Guide Sleeve See: Head Rest/Service and Repair.
3. NOTE: The seat track rear height adjust must be all the way up or the recliner cover post will not slide out of the seat track hole.
NOTE: For retainer clarity, inside of recliner cover shown.
Remove the recliner cover.
1. Remove the scrivet at the rear of the recliner cover.
2. Remove the screw at the rear of the recliner cover.
3. Slide the recliner cover post out of the seat track hole and remove the recliner cover.
4. If equipped, remove the manual lumbar handle.
1. Push the cushion trim cover and foam pad back and locate the manual lumbar handle clip under the cushion side shield.
2. Remove the clip and slide the manual lumbar handle off the shaft.
