Flex AWD V6-3.5L (2009)
NOTE: With the seat out of the vehicle and the backrest in the fold-flat position, the inboard latch foot must be in the latched position to pivot the
backrest back to the upright position.
1. Remove the 40 percent rear seat. For additional information, refer to Seat - Exploded View, Second Row See: Service and Repair/Second Row
Seating/Seat - Exploded View, Second Row.
2. Remove the 40 percent rear seat backrest. For additional information, refer to Seat Backrest - Second Row, 40 Percent See: Seat Back/Service
and Repair/Removal and Replacement/Second Row Seating/Seat Backrest - Second Row, 40 Percent.
3. Release the clip, separate the strut and the cushion trim cover hook-and-loop strips.
4. Release the cushion trim cover J-clip under the seat.
5. From under the seat and at the back, between the cushion foam pad and cushion frame, release the J-clip attached to the cushion frame.
6. Release the cushion trim cover from the flex mat.
1. Take the 4 cushion trim cover retainers out from under the second flex mat wire (1 shown).
