Flex AWD V6-3.5L (2009)
5. For driver seat, pull out and remove the cushion side shield cover.
6. For passenger seat, release the 3 clips, slide rearward and remove the cushion side shield cover.
7. Separate the safety belt anchor from the seat.
-
For driver seat, remove the safety belt anchor bolt and separate the safety belt anchor from the seat.
-
For passenger seat, disconnect the Belt Tension Sensor (BTS) electrical connector, remove the safety belt anchor bolt and separate the safety
belt anchor from the seat.
8. Separate the cushion side shield.
1. Remove the scrivet at the rear of the cushion side shield.
2. Remove the screw at the rear of the cushion side shield.
3. Remove the screw at the front of the cushion side shield.
4. Pull out to release the clips and separate the cushion side shield.
9. Separate the wire harness pin-type retainer, disconnect the seat control switch and remove the cushion side shield.
10. Pull the seat control switch knob(s) off the switch.
