Flex AWD V6-3.5L (2009)
Removal
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
WARNING: Always install new brake shoes or pads at both ends of an axle to reduce the possibility of brakes pulling vehicle to one side.
Failure to follow this instruction may result in uneven braking and serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Check the brake fluid level in the brake fluid reservoir.
-
If required, remove fluid until the brake master cylinder reservoir is half full.
2. Remove the wheel and tire.
3. Remove the brake caliper bolts.
4. NOTICE: Do not allow the caliper to hang from the brake hose or damage to the hose may occur.
NOTICE: Care must be taken when servicing rear brake components without disconnecting the parking brake cable from the brake
caliper lever. Carefully position the caliper aside using a suitable support or damage to the parking brake cable end fittings may occur.
Using hand force and a rocking motion, separate the brake caliper from the anchor plate. Position the brake caliper aside.
-
Support the caliper with mechanic's wire.
5. NOTICE: When the brake pads are separated from the brake caliper, new brake pads must be installed to prevent brake noise and
shudder. The brake pads are one-time-use only.
Remove and discard the 2 brake pads and spring clips from the brake caliper anchor plate.
6. NOTE: Do not remove the anchor plate guide pins. The guide pins are press fit to the brake caliper anchor plate. If the guide pins are damaged a
new anchor plate must be installed.
Inspect the brake caliper anchor plate assembly.
-
Check the guide pins and boots for binding or damage.
-
Install a new brake caliper anchor plate if it is worn or damaged.
Installation
